Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

基于SOM-SVM组合分类器的涂层防护性能研究

目的为避免EIS,EN技术可能出现的问题,建立一个准确、高效的评价模型,以探究现役军用有机涂层防护性能。方法利用电化学阻抗谱(EIS)、电化学噪声(EN)技术分析了两种军车有机涂层在循环暴露试验中的腐蚀行为,提取低频阻抗模值|Z|_(0.1 Hz)与涂层噪声电阻R_n两种电化学评价参数作为自组织神经网络(SOM)的输入训练样本,同时结合支持向量机(SVM)方法建立涂层防护性能组合分类器。结果将涂层失效过程自适应地分为涂层防护性能良好、防护性能下降、基本失效三个阶段。结论所建立的SOM-SVM组合分类器对于辅助分析涂层防护性能具有可行性。     

提升汇流环湿热环境适应性方法研究

目的提高汇流环在湿热环境下的适应能力。方法实物解剖,观察汇流环绝缘材料损坏情况、碳粉堆积情况,在不同温度、湿度下测试绝缘材料绝缘度、抗电强度,碳粉堆积和导电情况,比对不同绝缘材料性能,并找出最适合的绝缘材料,比对滚动汇流环、碳刷组件、刷丝组件,找到解决碳粉堆积的方法。结果汇流环受湿热影响会从接缝处和电缆连接处进入湿气,温度、湿度的上升会使得原绝缘材料性能下降,长时间使用汇流环,碳粉会在汇流环内堆积并受到湿热的影响而导电,局部密封汇流环可以减少湿气进入。PPO材料性能优异,可以替换原绝缘材料从而减少湿热的影响,使用刷丝组件替代碳刷可以避免碳粉的产生。结论综合运用局部密封、绝缘材料改进、碳刷组件改进三种措施,可以有效提高汇流环在湿热环境下的适应能力。     

碳量子点掺杂氮化碳提高的光电化学阴极保护性能研究

目的研究g-C_3N_4/C-Dots-M复合材料的光电化学阴极保护性能。方法采用X射线衍射(XRD)、扫描电子显微镜(SEM)和紫外可见漫反射光谱技术对样品的晶体结构、微观形貌和光吸收性能进行表征。通过电化学测试可见光照射下g-C_3N_4/C-Dots-M复合材料光电极偶联316L不锈钢后的光电化学阴极保护电流密度和电位变化曲线,研究材料的光电化学阴极保护性能。结果可见光照射下,该偶联体系的光致混合电位下降至-0.43 V(vs. Ag/AgCl),光电化学阴极保护电流密度达到4.3μA/cm。结论得益于碳量子点优异的电子传导特性,g-C_3N_4/C-Dots-550复合材料的光电化学阴极保护性能比纯g-C_3N_4的明显增强。该复合材料在光电化学阴极保护方面展现了较大的应用潜力。     

包装箱用碳纤维增强复合材料贮存寿命研究

目的研究碳纤维增强复合材料贮存条件下的性能变化趋势和寿命评估。方法对碳纤维增强复合材料开展四个不同温度条件下的热氧老化试验,按试验周期定期取样开展冲击性能测试,对试验数据采用寿命预估方法进行处理,对材料性能进行预估。结果通过数据计算分别得到我国热带海洋、干热沙漠等典型气候条件下的碳纤维增强复合材料贮存寿命分别为17.21~35.89年。结论碳纤维增强复合材料具有较好的贮存性能,在较为严酷的热带海洋气候和给定的失效判据条件下,寿命预计为17.21年。试验和数据处理方法可以较好地预计材料的性能变化趋势和开展寿命评估。     

有机硅改性环氧树脂的光固化动力学与性能研究

目的研究紫外光固化有机硅改性环氧树脂的固化行为和性能。方法通过介电分析(DEA)研究光引发剂、热引发剂及有机硅含量对紫外光固化脂环族环氧树脂反应过程的影响,利用热重(TG)、差示扫描热(DSC)和显微硬度仪对有机硅树脂改性环氧树脂性能进行分析。结果发现光引发剂与热引发剂对固化效率可起到协同互补的作用,增加光引发剂和热引发剂的浓度,可缩短引发时间,加快固化速率,提高固化效率。与纯环氧树脂相比,有机硅改性环氧树脂的固化效率和初始分解温度都有所下降,但高温阶段降解速率明显降低,500℃的残炭率也得到提高。当加入质量分数为10%的有机硅时,固化物表现出较好的耐热性能,树脂维氏硬度可达31.75HV。结论紫外光可以很好地固化有机硅改性环氧树脂。     

Concentration and Distribution of Persistent Organic Pollutants (POPs) in Harbour Dredging Sediments: A Pilot Study Using a Statistical Approach for a More Efficient Characterisation and Management

The Italian guidelines concerning the dumping of dredgingmaterials implies chemical, physical and microbiologicalcharacterisation of dumping sediments collected through aspecific sampling strategy.POP's such as PCB's and organochlorine pesticides, areconsidered as priority pollutants in all the InternationalConventions for the protection of the marine environment, inconsequence of their persistence, toxicity and bioaccumulation capacity.In the present article the concentrations and distribution ofPCB's and organochlorine pesticides in dredging sediments ofPiombino harbour (northern Thyrrenian sea) were investigates.The results showed high POP's concentrations in all the studiedareas. The maximum values were: 3.94 mg kg^-1 dry weight for PCB's(IUPAC Nos. 28; 52; 101, 118; 137; 153; 180; 209); 2.04 mg kg^-1 d.w.for HCH's (-, -, - and -hexachlorocyclohexane isomers); 0.28 mg kg^-1 d.w. for DD's (DDT + DDE + DDD).Subsequently, the data related to each pollutant were treatedwith statistical tests, in order to verify how well the samplingstrategy is able to represent the distribution of contaminantsin the dredging area. Finally, management strategies werederived for the studied dredging sediments.     

气体中毒窒息事故的环境应急监测

以株洲市攸县某矿业公司"5·7"重大中毒窒息事故的环境应急监测为例，详细阐述了该事故开展应急监测的全过程。针对锁定污染因子、查找污染源、判断污染团的扩散趋势以及监控敏感点的安全等监测目的设计监测方案。通过监测数据分析确定事故特征因子为CO，其周边环境空气中浓度随着与抽风口距离的增加而快速下降，监测到附近居民区环境空气质量未受事故影响。     

小清河水体和沿岸地下水中有机污染物的监测及其毒性分析

本文对小清河水体和沿岸地下水中的有机污染物进行了色－质联用分析，共检出有机污染物１３类９３种。并对其毒性效应进行了分析和评价。